Honeywell Home THM04R3000 Guia De Instalacion página 3

3
Link T10+ Thermostat to EIM
3.1 When the T10+ is powered, follow the onscreen prompts until it says "Do
you have an Equipment Interface Module (EIM)?". Select Yes, I have an
EIM.
3.2 Press and release the CONNECT button at the EIM when the thermostat
prompts you. Make sure the "Connected" light is flashing green. The EIM
will continue to flash the connected light for 15 minutes and reset this
timer every time a new RedLINK 3.0 device is added.
NOTE: If the "Connected" light does NOT flash green, another system may be
in the listening mode. Please exit the listening mode at the other system and
then try again.
• Green Flashing: In Listening Mode. System is ready to add RedLINK 3.0
devices.
• Green Steady: RedLINK devices are communicating.
• Red: RedLINK device(s) are NOT communicating. Check EIM and
RedLINK devices.
C O N N E C
T E D
C O N N E C
T
M34176A
3