Bestop 77336 Instrucciones De Instalación página 7

Section 3 Adjust Rails; Install Clamp Pads
Adjust the Side and Front and Rear
Rail assembly right-to-left to center it
on the bed width.
P7 - 77336 Rev. F 0922
Parts
Clamp Pad
Part #577.39
Qty. 2
Installation Instructions - Supertop for Trucks
Ó 7.5" 0 0 . 1
1
1 Attach a Clamp Pad to each Upper Clamp
on the Front Side Rails, on the rib
farthest from the side rail.
NOTE: The Clamp Pads must rest on top of
the bed rail cap after installation.
The Upper Clamp should be located 7.5" from
the end of the Front Side Rail.
2 Make two cuts in the seal on the
bottom of the front rail, in line with the inner
edge of the bed rail cap, so that the seal will
lay flat against the bed bulkhead.
Page 7
Make a cut in
the seal here,
on each end
of the front rail
2
© 2020 Bestop, Inc.