Replacing The Control Knob Led; Storage; Troubleshooting; Specifications - Furrion FGR24D3A1A-SS Manual De Usuario

Replacing the Control Knob LED

1. Disconnect the oven from the power supply by means of the
switch used to connect the appliance to the electrical mains
or fuse. Grasp and pull out the control knob with the broken
a
LED light. (Fig. 22 )
2. Remove the two screws holding the LED light guide using a
phillips screwdriver. (Fig. 22
3. Remove the LED assembly after disconnecting the wire from
the base of the LED PCB board. (Fig. 22
a b
Fig. 22
.

TROUBLESHOOTING

Before calling for service, review this list. It may save you both time and expense. This list includes common experiences that are not the
result of defective workmanship or material in your appliance.
Problem
Ensure gas supply valve is open.
Burner ports or slots are clogged. With the burner off, use a small-gauge wire or needle to clean ports or slots.
Burners do not light
During the lighting process of the cooktop burner or the oven pilot flame, ensure you hold the knob in for 5 to 10 seconds to ensure the
thermocouple is heated.
Low gas supply level in cylinder.
Moisture is present on the burner, dry burner thoroughly.
Burner flame burns
half way around
Burner ports or slots are clogged. With the burner off, clean ports with a small-gauge wire or needle to clean ports or slots.
Dust particles in main line. Allow the burner to operate a few minutes until flame turns blue.
Burner flame is
orange
In coastal areas, a slightly orange flame is unavoidable due to salt air.

SPECIFICATIONS

Top View
Specifications
BTU/HR
Fuel
Inlet Pressure
Voltage
Current Input
Inner Volume of the Oven
Overall Dimension (W x H x D) 243/4 x 257/8 x 269/16" (628 x 656 x 674mm)
b )
c
)
c
D
Left and Right Burner: 7500 BTU
Center Burner: 9000 BTU
Oven: 9500 BTU
Propane Gas
10" WCI Min to 13.8" WCI Max
DC 12V
2A
2.24 cu. ft.
4. Plug the wire harness connector into the new LED assembly.
5. Reattach the LED assembly to the console with the 2 screws
removed in step 3. Ensure the wires are not pinched during
this process.
6. Reattach the control knob by aligning the stem of the control
into the opening in the control knob housing and pushing it
back into position.

Storage

Dry all surfaces and burner box, then spray surfaces with cooking
oil substance to preserve the surface from rusting during long
term storage. Wipe off oil coating before reuse.
Possible Causes / Solution
W
H
Front View
This appliance conforms with the directives:
● CAN1-1.16-M79 (R2016)
● Canada, the Natural Gas and Propane Installation Code, CSA
B149.1.
- 14 -
19 ⁄ "
503mm
22 ⁄ -23½"
560-597mm
Side View
CCD-0005506 Rev: 08-16-22