Oven Installation - Furrion FGR24D3A1A-SS Manual De Usuario

3 8 1 m
1 5 " (
Fig. 2
The minimum horizontal distance(s) from sides and back of
appliance to adjacent vertical combustible walls extending above
the top panel: (Fig. 2)
Item
A 93/16" Min. (234mm Min.)
B 911/16" Min. (246mm Min.)
NOTE: These distances shall be from the burner center of the
appliance.

Oven Installation

NOTE: When the cabinet has been prepared according to the
dimensions given above (Fig. 1 and Fig. 2) and the gas line is in
place.
Remove the oven from its packaging and slide it 3/4 of the way into
the cabinet opening. (Fig. 3)
Fig. 3
Gas Connection
WARNING
Gas supply pipe must be installed with clearance from knives
contacting or cutting gas lines.
CCD-0005506 Rev: 08-16-22
m )
1 8 "
)
m m
( 4 5 7
Dimension
Connect a propane supply line with a ⅜" Flare Female
to the gas oven in the upper left rear corner of the cabinet as
shown below. Tighten the gas line joint to the gas oven using a
wrench.
G a s
IMPORTANT: Leave adequate space around the gas supply pipe
in case of bend or damage during installation. Make sure the gas
supply pipe cannot contact any moving parts after installed. Be
sure all openings in the cabinet around the gas line are sealed at
time of installation.
Check that the Connection is Tight
When installation is completed, check the pipe fittings for leaks
using a gas leak detection solution. Never use a flame.
NOTE: Let the hose unfold and extend naturally. Do not fold the
hose, do not put the hose against the back panel or vent channel
of the appliance. (Fig, 4)
Gas Pipe Cutout
Fig. 4
Leak Check
Leak testing of the appliance shall be conducted according to the
following instructions.
FIRE OR EXPLOSION
● Extinguish all open flames.
● NEVER leak test when smoking. Never use a flame.
● Do not use the appliance until connection has been leak
tested and does not leak.
● Pressure/Leak test using 11-13.8 WC pressure.
● Gas leaks may occur in your system and result in a
dangerous situation. Always perform a leak test for possible
leaks according to the manufacturer's instructions after
installation and before any operation.
● Gas leaks may not be detected by smell alone. Gas suppliers
recommend you purchase and install a UL approved gas detector.
- 7 -
P i p e
C u t o
u t
Gas Pipe Cutout
WARNING
WARNING
connection