Furrion CHILL FACR13HESA Serie Manual Del Usuario página 9

13. Connect the wires of the rooftop unit cable to the control
box. 115VAC power cord connects to 115VAC power source.
Rooftop Unit
Cable
14. Install the Air Distribution Box (ADB) shroud over the
mounting frame and fix with 4 self-tapping screws.
NOTE: Make sure the "THIS WAY FRONT" mark is facing
front (the direction of the vehicle) while installing.
15. Align the filter tabs with mating notches and push to snap
the filters into the ADB shroud.
115VAC Power
Cord
16. Install the two control knobs through holes on the
decoration plate and push to lock into place.
17. Install the screw caps to cover the screw holes.
Your new rooftop air conditioner has now been fully installed in
the RV roof.
- 8 -
Screw Cap
CCD-0005773 Rev: 04-25-22