Lindy 43202 Manual De Usuario página 4

User Manual
Specification
HDMI 2.0

DisplayPort 1.4

Maximum Bandwidth: 18G

HDCP 2.2/1.4 Pass-Through

USB 3.1 Gen 1 / USB 3.2 Gen 1 up to 5Gbps

Analogue Audio Stereo, sampling rate 24bit/96KHz

RJ45 Gigabit Ethernet 10/100/1000Mbps

Operating Temperature: 0°C - 55°C (32°F - 131°F)

Storage Temperature: -10°C - 70°C (14°F - 158°F)

Relative Humidity: 0 - 85% RH (Non-condensing)

Plastic and Aluminium Housing

Colour: Black

Power Requirements: AC100-240V 50/60Hz

Chipsets:

VL170 / VL160: Electronic switch
•
• FL7102 / FL7112: Protocol
• AX88179A: Gigabit Ethernet
GL3510: USB 3.0 hub
•
• KT0200: Audio
• RTD2142: Video
Installation & Operation
Front
DC 20V: Connect the 20V 6A Power Supply to give power to the docking station and provide 65W

power charging to PC2 host device.
PC2: Connect a Type C source using a USB 3.1 Gen1 (USB 3.2 Gen1) or above Type C Male to Male

cable. Please Note: Type C source connected must support DisplayPort Alternate mode, it can also
be powered from the Docking Station's power supply if supporting Power Delivery (up to 65W).
PC1: Connect a Type C source using a USB 3.1 Gen1 (USB 3.2 Gen1) or above Type C Male to Male

cable. Please Note: Type C source connected must support DisplayPort Alternate mode, it can also
be powered from the PD port connecting a Type C PD power supply (up to 100W).
SWITCH: for future use.

DP: Connect a DisplayPort monitor using a DisplayPort Male to Male cable.

HDMI: Connect a HDMI monitor using a HDMI Male to Male cable.

RJ45: Connect to a network LAN using a Cat.5e or above cable.

USB: Connect USB devices (support up to 5Gbps each port).

PD: Connect a Type C PD power supply to provide power on PC1 port. Please Note: Type C source

connected to PC1 port must support PD, the charging power depends on the PD power supply
connected (up to 100W).
English