VONROC LB502DC Traducción Del Manual Original página 8

EN
Model No
Battery Type
Voltage
Capacity
Recommended charger
Weight
Model No
Battery Type
Voltage
Capacity
Recommended charger
Weight
Model No
Charger input
Charger output
Charging time 2Ah battery
Charging time 4Ah battery
Recommended batteries
Weight
Only use the following batteries of the VONROC
VPOWER 20V battery platform. Using any other batte -
ries could cause serious injury or damage the tool.
CD801AA 20V, 2Ah Lithium-Ion
CD803AA 20V, 4Ah Lithium-Ion
The following charger of the can be used to charge
these batteries.
CD802AA Quick charger
The batteries of the VONROC VPOWER 20V battery
platform are interchangeable with all the VONROC
VPOWER 20V battery platform tools.
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN 50636-2-100;
it may be used to compare one tool with another
and as a preliminary assessment of exposure to
vibration when using the tool for the applications
mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
signifi cantly increase the exposure level.
8
CD801AA
• The times when the tool is switched off or when
Lithium-Ion
20V
2.0 Ah
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
CD802AA
your hands warm, and organizing your work pat-
0.3 kg
terns.
CD803AA
DESCRIPTION
Lithium-Ion
The numbers in the text refer to the diagrams on
20V
page 2-3.
4.0 Ah
1. On/Off button
CD802AA
2. Battery
0.65 kg
3. Battery unlock button
4. Upper tube
CD802AA
5. Lower tube
220-240V,50Hz 0.4A 6. Battery LED indicators button
7. Battery LED indicators
21V 2.5A
8. Charger
60 minutes
9. Charger LED indicators
120 minutes
3. ASSEMBLY
CD801AA, CD803AA
0.36 kg
Inserting the battery into the machine (Fig. A, C)
1. Insert the battery (2) into the base of the machi-
2. Push the battery further forward until it clicks
Removing the battery from the machine (Fig. A, C)
1. Push the battery unlock button (3).
2. Pull the battery out of the machine like shown
Checking the battery charging status (Fig. D)
• To check the battery charge status, push the
• The battery has 3 lights indicating the charge
it is running but not actually doing the job, may
signifi cantly reduce the exposure level.
Before any work on the power tool, remove
the battery.
The battery must be charged before fi rst
use.
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
ne as shown in Fig. C.
into place.
in Fig. C.
button (6) on battery shortly.
level, the more lights that burn, the more char-
ge the battery has left.
WWW.VONROC.COM