Sauder Harbor View Serie Instrucciones De Montaje página 7

Step 3
Fasten three PANELS (C) and both VERTICAL MOLDINGS (H)
å
to the BACK (D). Use sixteen BROWN 1" FLAT HEAD
SCREWS (W) through the BACK and into the PANELS and
VERTICAL MOLDINGS.
NOTE: Be sure the locator holes in the unfi nished surfaces
å
of the VERTICAL MOLDINGS are in the locations shown.
All the edges resting on the fl oor must be even. Start
each SCREW a few turns before tightening any of them.
Follow the diagrams closely.
These holes must be here.
BROWN 1" FLAT HEAD SCREW
(16 used in this step)
www.sauder.com/services
W
H
D
H
C
C
158022
The locator hole is positioned
in the unfi nished surface of
the VERTICAL MOLDING.
H
C
The locator hole in each
VERTICAL MOLDING must
be positioned toward the fl oor.
Page 7