To Start Engine - Craftsman 247.29935 Manual Del Operador

gAS AND OIL FILL-UP
Oil
(one bottle shipped with unit)
First Time Use
1. Remove oil fill dipstick.
2. With the tiller on level ground, use a funnel to empty entire
contents of oil bottle provided into the engine.
3. Replace oil fill dipstick and tighten.
Subsequent Uses
Only use high quality detergent oil rated with API service classification
SF, SG, SH, SJ or higher. Select the oil's SAE viscosity grade accord-
ing to the expected operating temperature. Follow the chart below.
˚ F
Although multi-viscosity oils (5W30, 10W30, etc.) improve starting
in cold weather, they will result in increased oil consumption when
used above 32°F. Check your engine oil level more frequently to avoid
possible engine damage from running low on oil.
1. Check the oil level making certain not to rub the dipstick along the
inside walls of the oil fill tube. This would result in a false dipstick
reading. Wipe dipstick clean with cloth. Replace dipstick into
the oil filler neck, but do not screw it in. Remove and check oil
level. Refill to FULL mark on dipstick, if necessary. Capacity is
approximately 20 oz. Overfilling will cause the engine to smoke
profusely and will result in poor engine performance.
2. Replace oil fill dipstick and tighten.
3. Keep oil level at FULL. Running the engine with too little oil can
result in permanent engine damage.
WARNINg
Use extreme care when handling gasoline. Gasoline is extremely
flammable and the vapors are explosive. Never fuel machine indoors
or while the engine is hot or running. Extinguish cigarettes, cigars,
pipes, and other sources of ignition.
gasoline
1. Remove fuel cap from the fuel tank.
2. Make sure the container from which you will pour the gasoline is
clean and free from rust or foreign particles. Never use gasoline
that may be stale from long periods of storage in its container.
Gasoline that has been sitting for any period longer than four
weeks should be considered stale.
3. Fill fuel tank with clean, fresh, unleaded regular gasoline only. Do
not use gasoline containing METHANOL. Replace fuel cap.
OPERATION
Alcohol blended fuels (called gasohol or using ethanol or methanol)
can attract moisture which leads to separation and formation of acids
during storage. Acidic gas can damage the fuel system of an engine
while in storage.
To avoid engine problems, the fuel system should be emptied
before storage for 30 days or longer. Drain the gas tank, start the
engine and let it run until the gas tank, fuel lines and carburetor are
empty. Use fresh fuel next season. See STORAGE Instructions for
additional information.
˚ C
Never use engine or carburetor cleaner products in the fuel tank or
permanent damage may occur.
NOTE: Check the fuel level periodically to avoid running out of
gasoline while operating the tiller.

TO START ENgINE

1. Attach spark plug wire and rubber boot to spark plug.
2. Fill tank to no more than 1/2 inch below bottom of filler neck to
provide space for fuel expansion.
3. Make sure the tine clutch control is disengaged.
4. Turn the fuel shut-off valve to the ON position.
5. Move the choke lever on the engine to CHOKE
warm engine may not require choking.) See Figure 13.
6. Move throttle control to START/RUN (Rabbit)
Figure 13.
7. Standing on the side of the unit, grasp starter handle and pull
rope out until you feel a drag.
8. Pull the rope with a rapid, continuous, full arm stroke. Keep a firm
grip on the starter handle. Let the rope rewind slowly.
13
CAUTION
CAUTION
CAUTION
STOP
Figure 13
position. (A
position. See