Location
The device should be installed far enough away from heat sources
such as radiators, boilers, direct sunlight, etc.
Warning !
It must be possible to disconnect the device from the mains supply; the
plug must therefore be easily accessible after installation.
Electrical connection
Before making the connection, make sure that the voltage and
frequency indicated on the nameplate correspond to your household
power supply. The device must be earthed. The plug of the power
supply cable has a contact for this purpose. If the household power
outlet is not earthed, connect the appliance to a separate earth in
accordance with applicable regulations, consulting a qualified
electrician. The manufacturer declines all responsibility if the above
safety instructions are not observed. This device complies with EEC
directives.
EN-16