Inserting/Changing The Batteries - Bosch Quigo Manual Original

24 | English
Cross line laser
Weight according to EPTA-Procedure 01:2014
– Cross line laser
– Holder
Dimensions (length × width × height)
A) The working range may be reduced by unfavourable environmental conditions (e.g. direct
sunlight).
B) At 20–25 °C
C) The values stated presuppose normal to favourable environmental conditions (e.g. no vi-
bration, no fog, no smoke, no direct sunlight). Extreme fluctuations in temperature can
cause deviations in accuracy.
D) Only non-conductive deposits occur, whereby occasional temporary conductivity caused
by condensation is expected.
The serial number (9) on the type plate is used to clearly identify your measuring tool.
Assembly

Inserting/changing the batteries

It is recommended that you use alkaline manganese batteries to operate the meas-
uring tool.
Push the locking mechanism (10) in the direction of the arrow to open the battery
compartment cover (7) and remove the battery compartment cover. Insert the bat-
teries supplied.
When inserting the batteries, ensure that the polarity is correct according to the il-
lustration on the inside of the battery compartment.
If the batteries become weak, the laser lines will flash quickly for a few seconds.
Always replace all the batteries at the same time. Only use batteries from the same
manufacturer and which have the same capacity.
1 609 92A 7L9 | (28.09.2022)
Quigo
0.27 kg
0.20 kg
65 × 65 × 65 mm
Bosch Power Tools