Important Safety Instructions - Sinbo SJ 3127 Guía De Uso

IMPORTANT SAFETY INSTRUCTIONS

Always make sure juicer cover is clamped securely in place before motor is
turned on.
Do not unfasten clamps while juicer is in operation.
Be sure to turn switch to OFF position after each use of your juicer. Make sure
the motor stops completely before disassembling.
Do not put your fingers or other objects into the juicer opening while it is in
operation. If food becomes lodged in opening, use food pusher or another
piece of fruit or vegetable to push it down. When this method is not possible
turn the motor off and disassemble juicer to remove the remaining food.
Do not use the appliance if the rotating sieve is damaged.
Unplug before cleaning and before assembling or removing parts.
Turn OFF before cleaning and before assembling or removing parts.
The cutting blade is extremely sharp so always use food pusher.
SPECIAL HELPFUL HINTS FOR THE BEST PERFORMANCE
Do not put any fruit or vegetable in your juicer until power is turned on.
Remove large seed from fruits such as peach, mango, etc. as the seed will
damage the blade of the unit.
The juicer has two speeds. High speed is for the hard fruits and vegetables
like apples, carrots etc...and low speed is for soft fruits and vegetables such
as watermelon, grapes and strawberries.
Do not use bananas or avocados as they do not contain juice and will clog
juicer.
Allow the juicer run for a few minutes before turning off to allow any excess
juice to be extracted from the pulp. Wait until motor stop spinning before
disassembling.
Do not immerse the whole machine into water or liquid at any time.
ASSEMBLY
Before first use it is a good idea to familiarise yourself with the assembly
/disassembly of the unit.
1. The appliance should be unplugged from the mains before assembly or
disassembly.
2. Place the pulp container under the nozzle on the left of the machine. Place
- 11 -