Tabla de contenido
Publicidad
General maintenance
• Remember to remove the batteries from the tool before
cleaning or servicing.
• All tool components are an important part of the
insulation system and should only be serviced by a
Authorized Service Center.
• When servicing the tool, ALWAYS ask for
original spare parts.
• When cleaning plastic parts, avoid using solvents. Most
plastic materials are susceptible to damage from various
types of commercial solvents.
• To clean dirt, carbon or dust use a clean cloth or
pressurized air.
WARNING
NEVER bring the tool into contact with
brake oil, petroleum-based products, penetrating oils, etc.
They contain chemicals that can damage or destroy the
plastic.
Repairs
• Use only spare parts and accessories recommended
by the manufacturer. In case the tool is not working,
repairs should be done in a
Authorized Service Center.
Storage
Neatly store the tool in a dry place and protected from
dust and water.
• Electrical appliances and batteries must not be disposed of with household waste. Please deliver this appliance and its
batteries with the contacts insulated with adhesive cloth to a recycling center. Check the location of the nearest center in
your community.
12
ENGLISH
Maintenance
WARNING
particles ALWAYS wear safety glasses with side shields or
face shield, in case of high dust ejection, also wear a dust
mask.
• It is not recommended that this tool is used for
extensive work on fiberglass, plasterboard, drywall or
plaster materials, since its particles are highly abrasive to
the components of any power tool. In case of using the
tool in any of these materials it is very important that it is
frequently cleaned with pressurized air to increase the
useful life of the tool.
Environmental protection
• When using pressurized air to clean
Publicidad
Tabla de contenido
