Maintenance - Truper ESMA-4512N Manual De Instrucciones

Useful Tips
• To prevent damaging the disc work using the disc into the right position.
• Press onto the work piece using less force than the tool's weight to avoid overload and
damaging the motor and disc.
• After installing a new disc allow it to rotate with no load at least during one minute. If it vibrates,
replace immediately.
• Avoid working onto wood or soft materials like lead. These materials saturate
CAUTION
the disc very fast and make it unusable.
• Before cleaning the tool disconnect the tool.
• Never use water or other liquids. Use only a brush.
• To avoid motor overheating clean the ventilation slots regularly.
• Double-check all the tool components are securely fastened.
• The housing should not be cracked or damaged.
• Double-check the power cable is not cut or peeled.
• After a prolonged use the grease on the tool head should be replaced in a
Authorized Service Center.
Repairs
Use only spare parts and accessories recommended by the manufacturer. In
the event the tool is not working, repairs should be carried out in a
Authorized Service Center.
Carbon Brush Replacement
• Replace worn (burnt, broken or smaller than 0.19" long) carbon brushes. Use
new carbons.
• When replacing carbons always replace both carbons at the same time.
• Remove worn carbons from the housing. Clean accumulated dust with
compressed air.
• Set the new carbons in a reverse order. Carbons should easily fall into the
carbon housing.
• After setting up new carbon brushes let the grinder running a couple of
minutes unloaded. This way the carbon brushes will adjust better.
• Use only original
specifically with the right strength and electric resistance for each type of motor.
Carbon brushes with different specifications may damage the motor.
Storage
Store the tool neatly in a dry place. Protect against dust and water.
8
ENGLISH
spare carbon brushes, designed
Start Up

Maintenance