Assembly And Disassembly Of Silicone - HUROM H-310A Serie Manual De Instrucciones

6. Assembly and Disassembly of Silicone

(The juicer may leak if the product is not assembled
properly.)
Extraction Packing
01
02
Seal Packing
01
02
01 Hold the silicone ring and pull it out smoothly.
02 After cleaning, plug the silicone ring upright into the
slot by fixing one end into place first.
03 Insert the rest and press down firmly
Juice Cap Packing
After cleaning, firmly insert with the round side outward and
the grid hollow facing upward.
Hopper Packing
Assemble the packings as shown in the figure.
Screw Packing
01 Grab onto one side and pull out.
02 After cleaning, check the top and bottom direction of
the packing and insert it upward as if you hook it on the
bottom of the multi-screw.
03 After checking the direction, press the rest of the
packing down without any folded part.
09