Installing The Cassette Toilet; Making Wall Cutouts - Dometic CT 4050 Instrucciones De Montaje

Installing the cassette toilet

6 Installing the cassette toilet
6.1 Installing the service door (accessories)
Model-dependent installation instructions are included with the service door
(Dometic SK4, SK5).
I
NOTE
Prepare the feed-through for the vent hose at the desired location
(chapter "Venting the cartridge tank (if a service door is installed only)"
on page 28).
6.2

Making wall cutouts

1. If a service door is installed: Follow the instructions of the installation manual that
comes with the service door.
2. Select the model-dependent template and place it on the outside of the vehicle.
The sample template (fig. 2, page 3) greatly reduced in size shows the tank
flap (1), the service door (2) and the filling for the service door (3).
3. Make a rectangular opening in the outer wall with the following dimensions
(fig. 3, page 4):
If a service door is installed only: Wall cut out for the service door
Service door wall cutout SK4:
– y = 25 mm
– b = 305 mm ± 1 mm
– h = 375 mm ± 1 mm
The dimension x results from the placement of the cassette toilet.
Service door wall cutout SK5:
– y = 12.5 mm, y
min
– b = 310 mm ± 1 mm
– h = 360 mm ± 1 mm
The dimension x results from the placement of the cassette toilet.
Model CTW4xxx only: Wall cutout for the tank flap
For the CTW4xxx model, mount a tank flap for the integrated water tank.
➤ Note the instructions in chapter "Installing the tank flap" on page 28.
24
= 28 mm
max
CT(E), CTLP, CT(E)S, CTW
EN