Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Carrier and Bucket Assembly
1. Fit the carrier frame on the base frame in place, make sure
the bolt of the carrier lock is inserted in the opening on the
side of the carrier frame, and the end pole of the carrier
frame is fit in the middle of the 2 panels under the base
frame, as shown. (Fig. 14).
Fig. 14
Carrier frame
2 Panels
End Pole
NOTE: Pull the lock backwards to insert the carrier
lock bolt in the opening of the carrier frame. You can
turn the lock knob 90 degrees to keep it unlocked while
assembling the carrier frame (Fig. 15).
Fig. 15
Pull back the lock
Turn the knob to
keep it unlocked
2. Insert the rotary rod into the aligned holes of the 2 panels
under the base frame and the end of the carrier frame,
and lock the assembly with 2 cotter pins on both sides
(Figs. 16 - 17).
Fig. 16
Rotary rod
Fig. 17
3. Fit the bucket onto the carrier frame, making sure the
4 holes on the bottom of the bucket are aligned with
the 4 holes on the carrier frame. Fix the bucket and
Carrier lock
carrier assembly with the provided 4 sets of bolts, spring
washers, flat washers and wing nuts, as shown. Tighten
securely for a stable assembly (Fig. 18).
Fig. 18
Flat washer
Spring washer
Wing nut
Operation
m
WARNING!
to make you careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
m
WARNING!
machine when you are assembling parts, making adjustments,
cleaning, or when not in use. Removing battery pack will
prevent accidental starting that could cause serious personal
injury.
13
Cotter pins
Bolt
Do not allow familiarity with this product
Always remove battery pack from the
Publicidad
Tabla de contenido
