Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2. Stand by the side of the wheelbarrow, pull out and turn
the carrier lock 90º (either direction) to unlock the carrier
frame (Fig. 15), and then lift and tilt the carrier frame
with the other hand (Fig. 28). When the carrier frame is
unlocked, you can release the carrier lock.
Fig. 28
3. After dumping the object, return the carrier and bucket
and make sure to lock the carrier frame.
m
CAUTION!
When dumping the object, hold the handle
and carrier frame firmly, and work in a stable posture.
m
CAUTION!
Keep the load to a minimum. If the load is
large, do not try to lift the carrier. Reduce the load, and then lift
the carrier.
Maintenance
Please contact an authorized Snow Joe
or call the Snow Joe
+ Sun Joe
®
at 1-866-SNOWJOE (1-866-766-9563) for all maintenance
operations not foreseen in this manual. Any operation
performed in an unauthorized service center or by unqualified
personnel will completely invalidate the warranty.
m
CAUTION!
Always be sure to park the machine on flat
ground and lock the brake lever before storage or attempting
to perform inspections or maintenance.
m
WARNING!
Always turn off the unit and remove the
safety key and battery pack before storage, inspections, or
maintenance.
m
WARNING!
When servicing, use only identical
replacement parts. Use of any other parts could create a
hazard or cause product damage.
General Cleaning
The wheelbarrow should be kept clean, dry. Use running water
to clean the outside of the unit and remove mud and dirt. Wipe
dry with a piece of cloth.
m
WARNING!
Never use gasoline, benzine, thinner, or
alcohol to clean the wheelbarrow. It may cause discoloration,
deformation or cracks on the unit.
Lift and tilt the
carrier frame
+ Sun Joe
dealer
®
®
customer service center
®
m
WARNING!
Do not use a pressure washer to clean
the unit. Water can penetrate tight areas of the machine and
cause damage to spindles, gears, bearings, or the engine.
Periodic Checks
To maintain the optimal performance of the machine, it's
recommended to run through the below checklist every few
months, or every time before using the machine.
• Check that the bolts and nuts are tightened firmly.
• Check that the carrier frame is locked securely when the
lock is fully engaged.
• Check that the brake lever works properly.
NOTE: If the brake lever reaches the handle when you
pull the lever, the brake is not working properly. Adjust the
brake as instructed below.
• Check to see if any wheel is damaged or flat.
Adjust the Brake
To maintain safe operation of the machine, it's very important
that the brake works properly. Check the brake often to see if it
will need adjustment. Make sure the brake lever stops halfway
when being pulled fully. When the brake lever can be pulled to
reach the handle, it needs adjustment as described below
(Fig. 29).
Normal
Fig. 29
1. Make sure the wheelbarrow is completely shut down with
battery and safety key removed.
2. Remove bucket, and then tilt the carrier frame (Fig. 30).
Fig. 30
16
Needs
adjustment
Carrier frame
Publicidad
Tabla de contenido
