Assembly Instructions; Auxiliary Handle Assembly; Depth Stop Assembly; Drills And Accessories Assembly And Replacement - VITO PRO POWER VIBE1050A Manual De Instrucciones

ASSEMBLY INSTRUCTIONS

Auxiliary handle assembly

The position of the auxiliary handle (14) can be adjusted to
ensure a safe working posture and with little fatigue for the
user.
1. Place the ring of the auxiliary handle on the drill by the side
of the quick bushing (1);
2. Adjust the auxiliary handle to the desired position and tighten
the handle by turning the fixing screw (15);
3. To remove the auxiliary handle, loosen the fixing screw and
remove it.

Depth stop assembly

To adjust the depth of the holes to be drilled, use the depth stop
(5).
1. Press the depth stop fixing (3) into the auxiliary handle and
insert the depth stop with the scale facing outwards;
2. Adjust the depth stop until the distance between the drill bit
and the end of the depth stop corresponds to the required
drilling depth;
3. Release the fixing button.

Drills and accessories assembly and replacement

The impact drill can be used to perform drills and
tightening/loosening operations. For this drill and tightening
accessories are used.
Never assemble or change drill bits and accessories while the
drill is running. Always disconnect the drill before performing
these operations.
1. Hold the fixed base of the drill chuck adapter (2) with one
hand and loosen the drill chuck (1) counterclockwise until the
opening permits the drill or accessory insert;
2. Insert the drill or accessory into the drill chuck opening;
3. Hold the drill chuck adapter in one hand and tighten the drill
chuck clockwise until the drill or accessory is properly fixed;
4. Make sure the chuck is tight using the provided spanner;
5. To remove the drills or accessories, repeat point 1;
When using screwing bits s always use a universal bit accessory.

OPERATING INSTRUCTIONS

The equipment is designed to perform impact drilling on
concrete, masonry and stone. It is also suitable for drilling
without impact on wood, metal, ceramic and plastic.
Equipment's with electronic control and right/left rotation are
also suitable for screwing.
When working with the impact drill, you should take into
consideration some care and procedures of use:
▪ Always use the auxiliary handle correctly placed and hold the
power tool with both hands. Losing the control of the power
tool may cause serious injuries;
▪ When working with loose or small pieces, use the fixing
devices to adjust them;
▪ Do not apply too much pressure against the working
piece/object. If the speed decreases abruptly, reduce the
pressure;
▪ When the tool gets stuck, turn off the equipment
immediately. Avoid the high reaction torques that cause the
backlash;
▪ Never leave the impact drill before the rotating part is
completely stopped;
▪ Always wear hear protection when using this type of
equipment. Exposure to loud noises may cause hearing loss;
▪ Make sure the power cord is always behind the machine
while operating with it;
▪ Turn off the machine in case of:
- Spark and/or smoke formation in the carbon brushes;
- Lubricant leaking through the vent grid;
- Damages in the impact drill's housing;
- Damages in the "ON/OFF" switch;
- Smoke or burnt smell appearance.
29