Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
If the timer is set on more than one zone:
1. When you set the time for several cooking zones simultaneously, decimal dots of the relevant cooking zones
are on. The minute display shows the min. timer. The dot of the corresponding zone flashes.
2. Once the countdown timer expires, the corresponding zone will switch off. Then it will show the new min. timer
and the dot of corresponding zone will flash.
Note: Select the heating zone, and then touch
LOCKING THE CONTROLS
You can lock the controls to prevent unintended use (for example children accidentally turning the cooking zones
on).
When the controls are locked, all the controls except the ON/OFF control are disabled.
To lock the controls
Touch the keylock control. The timer indicator will show " Lo "
To unlock the controls
1. Make sure the ceramic hob is turned on.
2. Touch and hold the keylock control for a while.
3. You can now start using your ceramic hob.
When the hob is in the lock mode, all the controls are disable except the ON/OFF, you can always turn
the ceramic hob off with the ON/OFF control in an emergency, but you shall unlock the hob first in the
next operation
OVER - TEMPERATURE PROTECTION
A temperature sensor equipped can monitor the temperature inside the ceramic hob. When an excessive
temperature is monitored, the ceramic hob will stop operation automatically.
RESIDUAL HEAT WARNING
When the hob has been operating for some time, there will be some residual heat.The letter " H "appears to warn
you to keep away from it.
AUTO SHUTDOWN
Another safety feature of the hob is auto shutdown.This occurs whenever you forget to switch off a cooking
zone.The default shutdown times are shown in
the table below:
Power level
Default working timer (hour)
(Set to 15 minutes)
(Set to 45 minutes)
control to cancel the timer.
1
2
3
4
8
8
8
4
5
6
7
8
4
4
2
2
-45-
9
2
Publicidad
Tabla de contenido
