Installation - Jocel JP2EV010148 Manual De Instruciones

Placa vitrocerámica
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION

Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 50mm space shall be preserved around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select heat-resistant work surface material to
avoid larger deformation caused by the heat radiation from the hotplate. As shown below:
L (mm)
W (mm)
288
520
Under any circumstances, make sure the ceramic cooker hob is well ventilated and the air inlet and outlet are not
blocked. Ensure the ceramic cooker hob is in good work state. As shown below:
Note: The safety distance between the hotplate and the cupboard above the hotplate should be at least
760 mm.
A(mm)
B (mm)
760
50 mini
H (mm)
D (mm)
52
47
C (mm)
20 mini
A (mm)
B (mm)
275
512
D
Air intake
-50-
X (mm)
50 mini
E
Air exit 5mm

Publicidad

Tabla de contenido
loading

Tabla de contenido