Assembly - Truper MAX-40D Manual

Bicycle type handle
• Loosen the knob (A) to open the clamp (B).
• Place the handle (C) on the clamp mount (D).
• Close clamp (B) and tighten knob (A) to secure in
position.
• Secure the cable to the shaft with the supplied clips
(E).
A
C
D
F
Straight shaft
• Match the notch in the straight shaft (F) with the slot in
the mount hole (G).
• Insert the straight shaft into the mounting hole as far as it
will go to make the electrical connection.
• Tighten the butterfly knob (H) to secure the straight shaft
in place.
Bicycle type handle adjustment
• To adjust the bicycle type handle (C), loosen the knob
(A), move the handle to the most comfortable position for
the operator and tighten the knob.
C
ENGLISH
8
B
E
G
H
A

Assembly

Guard
• Match the slot in the guard (I) with the notch in the
cutting head (J).
• Secure the guard to the cutting head with the three
screws provided.
I
• When using the string trimmer with the string trimmer
head (K), the guard extension (L) must be installed.
- Attach the extension to the guard by means of the two
screws provided.
K
Harness
• Attach the harness latch to the
axle eye.
• The eyelet has a screw to secure
its position. Loosen the screw with
the Allen wrench, run the eye
along the shaft to the most
comfortable position for the
operator and then tighten the
screw.
J
L