Troubleshooting; Maintenance; Cleaning And Care; Environmental Protection - Truper MAX-40D Manual

Troubleshooting

Problem
String trimmer loses
efficiency.
Trigger cannot be
pulled.
Trigger can be pulled
but head will not
rotate.
The battery is leaking.
Battery does not
charge and charge
level indicator light
does not turn on.
The string trimmer
heats up after
prolonged periods of
work.
Battery heats up
during operation.
Battery heats up
during charging.
Charger heats up
during charging.

Maintenance

Cleaning and care

• Regularly inspect all mounting screws and make sure that
they are tightened correctly. If any of the screws are loose,
tighten them immediately.
• Use a clean, soft cloth to clean the tool. Never use
alcohol or detergent. Remove batteries from tool before
cleaning.

Environmental protection

Electrical appliances and batteries must not be disposed of with household waste. Please deliver this appliance and its
batteries with the contacts insulated with adhesive cloth to a recycling center. Check the location of the nearest center in
your community.
Cause
• Low battery.
• The switch lock is locked.
• The battery is not charged.
• Tiny drips may occur in extreme temperatures
or after heavy use, this is normal.
• Heavy or very noticeable dripping is due to a
damaged battery.
• Charger connection improperly installed on
battery.
• Incorrect charger connection to the socket.
• This heating is normal.
• This heating is normal, as the energy extracted
from the battery while the string trimmer is
running causes the battery to heat up.
• This heating is normal, resulting from the
chemical reactions that occur inside the battery
while it is charging.
• This heating is normal, resulting from the
voltage regulation.
Solution
• Charge the battery.
• Press the switch lock to unlock.
• Charge the battery.
• Immediately clean liquid from skin or clothing
with soap and water.
•Replace the battery immediately.
• Insert the charger connection to the battery
correctly.
• Check that the charger plug is properly
connected to the socket.
• Allow the string trimmer to cool down for 5
minutes.
• Stop the string trimmer for 5 minutes to allow
the battery to cool down.
Service
• Tool service should only be performed at
. Service and maintenance by
unqualified persons can be dangerous and may result in
personal injury and void the product warranty.
ENGLISH
13