Hikmicro ALPEX Serie Guia De Inicio Rapido página 9

3. Turn the battery cover clockwise to tighten it.
Note:
● Take the battery away if you do not use the device for a long time.
● The external removable battery type is CR123A, and the battery size
should be 16.5 mm × 34 mm. The max. rated voltage and capacity are
3 VDC and 1600 mA.
● The built-in battery type is 18650 with the protection board, and the
battery size should be 23 mm × 67 mm. The rated voltage and capacity
are 3.6 VDC/3350 mA (12.18 Wh).
3. Install Rail Bracket (Page 2 – C)
Steps
1. Remove the screws with the Allen wrench to disassemble the rail
bracket top.
2. Put the device to the rail bracket, and align the screw holes on the rail
bracket top with those on the rail bracket bottom.
3. Insert and tighten the screws.
Note:
● The rail bracket may vary according to different models. Please refer to
the actual product.
● Please purchase the rail bracket in advance.
4. Install IR Torch (Page 3 – D)
Steps
1. Open the IR torch bracket, and put the device to IR torch bracket.
2. Lock the lever by pressing it to fix the bracket as figure shows.
3. Turn the IR torch battery cover anticlockwise to remove it, and thread
the IR torch through the bracket hoop, then turn the IR torch battery
cover clockwise to tighten it.
4. Tighten the screws to fix the IR torch.
Note:
● Rotate the lever to adjust the IR torch bracket. The lever would
disassemble if continuously rotating it anticlockwise. Turn the lever
clockwise to install it.
7