Corradi PERGOTENDA 100 INCLINADO Manual Del Usuario página 47

ADJUSTING THE COMMANDS
ELECTRIC DRIVE TYPE 2 (SLOPE 95 MOTOR)
LIMIT STOP ADJUSTMENT SLOPE 95 MOTOR
Proceed with maximum caution in accordance with the safety
regulations in force.
- Check that the motor is correctly connected to the exchange
and that the exchange is correctly connected to the mains.
If not present make the connections as indicated in the wiring
scheme.
- Push the START button (1) on the remote computing system
exchange and wait for the led to turn RED (2), and then release the
switch.
The awning starts to descend; once it gets to the limit switch it
will stop for about 1 second and then it will move upwards
automatically.
- Push the STOP button (3) as soon as you reach the point where
you would like to have the limit switch on the upper side.
It is then possible to use the remote control supplied.
Then proceed with assembly of the awning. The tension of the
canvas when opening is managed by the exchange, whilst the
point at which the stacked awning stops is the point
memorised with the STOP button. If the motor stops (because
of overheating), the red LED (2) flashes: after approximately 5
minutes the light goes off and the motor can be used again.
Tuning a new remote control
Press the MEMO button (4), the LED (5) flashes twice, keep the
MEMO button (4) pushed down and press the remote control
button at the same time, the LED (5) flashes twice indicating
that the remote control has been recognised.
Cancelling remote control memory:
You can cancel all the remote control codes by pressing the
CANC button (6) and waiting for the LED (5) to stay
permanently red.
46 of 119
MONO 00749 Exchange
With automatic opening limit switch
including a remote control.
5 6
4 3
2 1
M1
Fu 250V/200mA
Push-button panel maintained,
supplied and installed by an electrician.
Positioned within the awning's
operating field
CORRADI S.P.A. - USER MANUAL - PERGOTENDA 100
SLOPE 95 Motor
230 V/50 Hz
In= 0,97 A
Pn= 218 W
IP= 54
1
2
3
3 1
2
3 - 04.2011