Extension Cord; Installing The Stainless Steel Handle - NewAir NCR053SS00 Manual Del Propietário

EXTENSION CORD

Because of potential safety hazards under certain conditions, it is strongly
recommended that you do not use an extension cord with this appliance.
However, if you must use an extension cord, it is absolutely necessary that it be
a UL/CUL-Listed, 3-wire grounding type appliance extension cord having a
grounding type plug and outlet and that the electrical rating of the cord be 110
volts.

INSTALLING THE STAINLESS STEEL HANDLE

To install the handle, follow the instructions below:
1. Remove the rubber gasket from the right side of the inside of the door
(you don't need to remove the whole gasket, just the side that covers the
openings for the screws).
2. Remove the screws from the included bag. Feed the screws through the
holes from the inside until they poke through to the outside front of the
door frame.
3. Align the handle with the two screws, then tighten the screws into the
handle using a screwdriver until the handle is both flush and secured
tightly against the door frame. DO NOT over-tighten the screws, as you
may cause damage to the door frame.
www.newair.com
EN
11