gs yuasa YCX6 Guia Del Usuario página 6

Dual clamp to eyelet conversion
The charger is supplied with clamps that feature integrated eyelets. To convert the clamp
into an eyelet, simply remove the retaining screw and washer. To reattach the clamps, follow
this process in reverse (image 1).
1
The eyelets can be used for permanent connection to a battery whilst it is fitted in a vehicle.
They should be securely tucked out of the way and connected to the charger when using the
connection plug when charging is required (image 2).
Selecting the correct MODE for your battery type
MODE
AGM WET
GEL
12 Volt
WET MF, SMF, EFB, CaCa, CaSb, SbSb
AGM AGM
GEL GEL
Li Lithium-ion, LifePO4
Press the MODE button to select the correct charging mode for your
battery type. The charger will automatically remember the previous
setting.
AMP
When Li mode is selected, the charger will detect that it is connected
to a lithium-ion or LifePO4 battery.
If the battery's BMS protection has been triggered due to low
Voltage, the charger will automatically compensate for this to enable
the battery to be charged.
2
6