Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3.
If battery acid contacts skin or clothing, wash immediately
with soap and water. If acid enters eye, immediately flood
eye with running cold water for at least 10 minutes and get
medical attention immediately.
4.
Be extra cautious to reduce risk of dropping a metal tool
onto a battery. It might spark or short circuit the battery or
another electrical part that may cause explosion.
5.
Remove personal metal items such as rings, bracelets,
necklaces and watches when working with a lead-acid
battery. A lead-acid battery can produce a short-circuit
current high enough to weld a ring or the like to metal,
causing a severe burn.
6.
Use the jump starter for jump starting lead-acid batteries
only. Do not use for charging dry-cell batteries that are
commonly used with home appliances. These batteries
may burst and cause injury to persons and damage to
EN
property.
7.
NEVER charge or jump start a frozen battery.
4
8.
To prevent arcing, NEVER allow clamps to touch together
or to contact the same piece of metal.
9.
Do not disassemble, bump, squeeze, puncture or
penetrate the product.
10. Keep jump starter dry, clean and oil-free. Be sure to use a
clean cloth when cleaning and do not use any corrosive
solvent.
11. The battery terminal not connected to the chassis has to
be connected first. The other connection is to be made
to the chassis, remote from the battery and fuel line.The
battery charger is then to be connected to the supply
mains
12. After charging, disconnect the battery charger from the
supply mains. Then remove the chassis connection and
then the battery connection
SAFETY WARNINGS FOR BATTERY CELLS INSIDE THE TOOL
a)
Do not dismantle, open or shred cells.
b)
Do not short-circuit charging terminal. Do not store
power tool haphazardly in a box or drawer where
charging terminal may short-circuit each other or
be short-circuited by conductive materials. When
power tool is not in use, keep it away from other metal
objects, like paper clips, coins, keys, nails, screws or other
small metal objects, that can make a connection from one
charging terminal to another.
c)
Do not expose power tool to heat or fire. Avoid
storage in direct sunlight.
d)
Do not subject power tool to mechanical shock.
e)
In the event of battery leaking, do not allow the
liquid to come into contact with the skin or eyes. If
contact has been made, wash the affected area with
copious amounts of water and seek medical advice.
f)
Keep power tool clean and dry.
g)
Wipe the charging terminals with a clean dry cloth if
they become dirty.
h)
Power tool needs to be charged before use. Always
refer to this instruction and use the correct charging
procedure.
i)
Do not maintain power tool on charge when not in
use.
j)
After extended periods of storage, it may be
necessary to charge and discharge the power tool
several times to obtain maximum performance.
k)
Recharge only with the charger specified by Worx.
Do not use any charger other than that specifically
provided for use with the equipment.
l)
Keep power tool out of the reach of children.
m) Retain the original product literature for future
reference.
n)
Dispose of properly.
Publicidad
Tabla de contenido
