Assambling; Setting Up The X-Bike - Crane FLX-XB-01 Manual Del Usuario

Assambling

children, protruding into or
located in the movement area,
which could influence the
training or cause injuries. We
recommend a safety distance
of 59" x 59" (150 cm x 150 cm)
around the unit. Leave or store
the X-Bike so that children
cannot injure themselves.
Assembling

Setting up the X-Bike

CAUTION!
Risk of injury!
Improper set-up and
use of the X-Bike may
result in injury.
− When setting up the X-Bike,
make sure not to squash
your fingers.
1. Pull out the safety pin (see Fig. B)
10
and then reinsert it into the appropri-
ate hole after fully unfolding the
product (see Fig. B).
2. Fasten the front stand, which has
transportation wheels attached
5
bolts , 2 curved washers and 2 M8 hex nut caps
11 16
stand to the rear main frame
6 2
(see Fig. C).
and 2 M8 hex nut caps
18
3. The left and right pedals ( and
8L 8R
Mount the pedals to the corresponding cranks. When you are sitting on the bike,
the right pedal is on your right (see Fig. D).
8R
14
B
1
10
C
2
1
18
16
18
6
16
11
to the front main frame using 2 carriage
1
. Then fasten the rear
18
using 2 carriage bolts , 2 curved washers
11
) are marked with "L" and "R" respectively.
Please note that the right
10
pedal screws on clockwise and
the left pedal counter clock-
wise.
4. Fasten the seat
10
using 3 hex head screws
3
washers
front main frame
holes above one another and then
fasten the seat to the pillar using the
club knob
be used to set the correct seat height
(see Fig. E).
Risk of injury!
The mark MAX
18
pillar must be completely visible
16
at MAXIMUM height
5
11
Setting the correct seat height
is important. Sit on the seat
and place your feet on the
pedals. You should be able to
16
move through a complete
pedal stroke without locking your knees or shifting your hips on
the seat. The seat is too close to the pedals if you have more than
a slight bend in your knees at the bottom of the pedal stroke. The
seat is too far from the pedals if you have to completely straight-
D
NOTICE!
8L
to the seat pillar
7
and 3
19
, and then insert it into the
15
. Position the
1
. The club knob can
9 9
E
WARNING!
7
on the seat
A
Fig. .
(see E)
NOTICE!
Assambling
21L
1
21R
8R
15
19
3
A
9
1
15