T Roubleshooting; R Epair; Arranty; S Torage - SUHNER ABRASIVE MSRT-1000 Documentación Técnica

The meter is now in charge mode. As soon as the symbol
(1) is no longer displayed, the battery is fully charged. The
battery takes around 3 hours to charge.
4.2 t
rouBleshooting
If the measuring probe freezes halfway along the length,
press the «RESET» button and start the measurement
again.
4.3 r
epAir
If, despite thorough manufacturing and testing proce-
dures, the roughness tester fails, then the repairs must be
carried out by an authorized SUHNER Customer Service
Center.
4.4 w

ArrAnty

The warranty becomes void in the event of damages/sub-
sequent damages due to improper handling, improper
use, non-compliance with the service and maintenance
requirements and use by unauthorized persons. Claims
shall only be recognized if the meter is returned in a com-
plete, non-dismantled state.
4.5 s
torAge
Temperature range: -15°C to +50°C
Max. relative air humidity: 90% at +30°C, 65% at +50°C
4.6 d / e
isposAl nVironmentAl compAtiBility
The roughness tester is made of materials that can be
recycled.
Before disposal, render the roughness tester inoperable.
Do not dispose of the roughness tester with
household waste.
The national regulations stipulate that this rough-
ness tester must be recycled in an environmentally friend-
ly manner.
Batteries and battery packs may not be disposed of in
domestic waste, burned, or discarded in water. Batteries
and battery packs should be collected, recycled, or dis-
posed of in an environmentally friendly disposal cycle.
22