Installation; Electrical Connection - FRICON THB Serie Manual De Mantenimiento

THG THB HCE HDNL
WARNING
•
Do not allow children to play with the packaging or its parts as they present a risk of
asphyxiation.
•
Damaged equipment may cause a short circuit or ground fault. Do not, under any
circumstances, connect damaged equipment to the electric circuit.
•
Care must be taken when transporting this equipment as there may be rollover risk.
•
Do not move the equipment on uneven floors.

5.Installation

NOTES:
•
For the equipment's proper installation, check its placement on a levelled surface
away from sources of heat and/or direct solar radiation and doors, windows, fans,
and vents.
•
Advertising labels may only be placed in the form of thin film. Do not affix thick
insulation materials on the outer walls.
•
Shelves and dividers need to be assembled and no product shall be placed on the
base plates.
•
In case of equipment with an automatic defrost system, to conserve and display
frozen products in bulk, appropriate baskets must be used to prevent the products
from falling or touching the walls of the equipment.
•
In variable speed equipment, in humid
environments with a large concentration of
salt, such as fish markets, pay special
attention so that water does not come
directly into contact with the compressor
area.
•
Make sure that air circulates freely around
the equipment complying with the minimum
150 mm distances illustrated in Figure 5.

6.Electrical Connection

NOTES:
•
Connect the equipment to an outlet that is properly grounded. This connection is
mandatory.
•
Check if the power source's voltage and respective frequency correspond to the
recommendations in the equipment's rating plate found on the back (Fig.4).
•
The maximum impedance of the equipment's power supply network should be 0.33
ohms.
Fig.5 - Minimum Distances for Installation
27
English