Important Safety Precautions - Concept ZS8010 Manual Del Usuario

EN
ACKNOWLEDGMENT
Thank you for purchasing a Concept product. We hope you will be satisfied with our product throughout its service life.
Please study the entire Operating Manual carefully before you start using the product. Keep the manual in a safe place
for future reference. Make sure other people using the product are familiar with these instructions.
Technical parameters
Voltage
Power input

IMPORTANT SAFETY PRECAUTIONS:

• Use the unit only as described in this operating manual.
• Make sure the mains voltage corresponds to the values on the rating plate. Use grounded wall outlets only.
• The unit reaches high temperatures during operation and remains hot for some time after being turned off. Do not
touch the hot surfaces. Use the handles and buttons. There is a risk of being burned.
• Do not leave the unit unattended while it is turned on, or even only plugged into the wall outlet.
• Unplug the unit from the wall outlet if not in use.
• When disconnecting the unit from the wall outlet, never pull the power cord. Grasp the plug and disconnect it by
pulling.
• Do not allow children or unskilled people to handle the unit. Use the unit out of the reach of these individuals.
• Take extra care when using the unit near children.
• Don't let anyone use the appliance as a toy.
• Use only accessories recommended by the manufacturer.
• Never use an appliance with a damaged power cord or plug. Contact an authorized service center immediately to
have the defective components repaired or replaced.
• Keep the appliance away from heat sources such as radiators, ovens, etc. Do not expose the product to direct sunlight
or moisture.
• Do not touch the unit with wet or damp hands.
• The unit is suitable for domestic use only. It is not designed for commercial operation.
• Do not immerse the power cord, plug, or appliance into water or any other liquid.
• Check the appliance and its power cord for damage regularly. Do not switch on a damaged unit.
• Turn the unit off, unplug the power cord from the wall outlet, and let the unit cool down before cleaning and after
use.
• Unplug the unit from the power source before filling the water tank.
• The filling hole cannot be open during operation.
• When connecting and unplugging the unit, set the temperature regulator to the minimum.
• The unit must be used and stored on a stable surface.
• Make sure the surface on which the stand is placed is stable, when putting the unit on the stand.
• Do not use the unit if it has been dropped, if there is any visible damage, or if it does not seal.
• Do not repair the appliance yourself. Contact an authorized service center.
• Prevent any contact of the power cord with hot surfaces.
• The high temperature during operation can cause burns.
• Make sure the power cable does not overhang the working area, and that children cannot reach it.
• Store the unit in a vertical standing position. Let the unit cool down before storing it. Do not touch the hot surfaces.
Failure to follow the manufacturer's instructions may lead to refusal of warranty repair.
ZS8010
230 V ~ 50 Hz
1100 W
21