Product Description - Concept ZS8010 Manual Del Usuario

PRODUCT DESCRIPTION

1. Water tank release latch
2. Spray button
3. Water tank
4. Temperature controller
5. Supply cable joint
6. Heating indicator
7. Ironing surface
8. Spray nozzle
9. Standing surface
OPERATING INSTRUCTIONS
Do not leave the unit unattended if it is connected to a power source.
Remove all stickers and packaging from the ironing surface before the first use.
Before the first use, try the unit on a piece of old fabric to make sure the ironing
surface and water tank are perfectly clean.
The unit may emit a slight odor during the first use. This smell will vanish after
a short time.
FILLING THE WATER
1. Unplug the unit from the power source.
2. Push the water tank release latch to loosen the front part of the unit with the
water tank, spray button and nozzle.
3. Remove the water tank and fill it with water. The capacity of the tank is about
30 ml.
4. Follow the reverse procedure to assemble the front part, and put it back. Continue
pushing until you hear a clicking sound, which indicates that the correct position
has been reached (Fig. 1).
SPRAYING
Push the spray button (Fig. 2), the water is released through the spray nozzle. You
will need a sufficient volume of water in the tank to activate this function.
IRONING
1. If you want to use the spray or steam function, fill the tank with water (see Filling
with Water).
22
2 1
8
3
EN
Fig. 1
Fig. 2
ZS8010
5
9
6
4
7