auna W2-AC400 Manual De Instrucciones página 19

5. Input sensitivity control
• Adjust the input sensitivity to match the output signal of the car radio.
6. Connecting the speakers (stereo & mono)
• Connect the speakers as shown in Figure 1.2 (next page).
Please note:
• The amplifier requires 7.5 A / 15 A / 20 A at maximum power. Using the
amplifier while the motor is off may drain the battery. Please always
switch on the motor before using the amplifier.
• Only use power cables with a suitable cross-section.
• This device is suitable for speakers with an impedance of 2-16 Ω .
The speakers must have enough capacity to absorb more of the unit's
power.
Overview of the connections
EN
19