Operation; Basic Operation - Furrion FSB2N25MC-BL Manual De Usuario

OPERATION

Basic Operation

1. Turn the unit On/Off
When the unit is off, press POWER button to switch the unit on. When the unit is
on, short press POWER button to switch the unit off.
2. Select function mode
Press MODE button repeatedly to select RADIO, USB (only available when a USB
storage is inserted), AUX IN, TV, DVD or BT mode.
3. Adjust the volume
During playback, press VOLUME +/VOLUME - button to increase/decrease the
volume.
4. Mute or resume sound
During playback, press MUTE button to silence the unit, press again to resume
the sound immediately.
5. Select and adjust the mode of the sound and menu
Press SEL button repeatedly to select the mode of VOL, BAS, TRE(treble), BAL
(balance), LOUD OFF/LOUD ON, EQ OFF/FLAT/ROCK/POP/CLASSIC, RPT
OFF/RPT ONE/RPT DIR (in USB mode), RDM OFF/RDM ON (in USB mode),
DEVOL, DX/LOCAL (in RADIO mode), STEREO/MONO (in RADIO mode) in the
sequence and circulation.
Press VOLUME +/VOLUME - button to select your desired mode.
NOTE: DEVOL – When armed, it will re-instate the volume control to a default
level lower than 60% after the unit is turned on. When disarmed, the volume
control setting after powering on the unit will be set to the same level as last used
before switching off the unit (even volume maximum).
This function avoids people get shocked when turning on the next day / blasts
with very loud sound levels.
6. Select a preset EQ mode
Press EQ button repeatedly on the remote control to select the preset music
equalizer curves: EQ OFF, CLASSIC, POP, ROCK, FLAT. The sound effect will be
changed accordingly.
7. Select the speaker ZONE 1/2
Press ZONE1/2 button to turn on or off the audio source in each of speakers.
The corresponding icon "ZONE 1 "or "ZONE 2" will be displayed on LCD once it is
selected.
8. Reset the unit
If the display is incorrect, or the function buttons are not effective or the sound is
distorted, switch the unit to AUX IN mode, press and hold MODE button for more
than 6 seconds to make the unit return to factory default settings and re-instate
the correct functions.
- 6 - CCD-0005530 Rev: 06-08-22