Service Centre; Cleaning And Maintenance - Max 31131 Manual De Instrucciones

Do not put pressure on the saw.
Switch the saw off immediately if the blade
jams or gets stuck in the item being cut.
If the blade gets stuck, it can cause the item
to violently kick back towards the user. Never
stand directly behind the saw blade when
sawing.
Never pull the item backwards while the saw
is running.
Switch the saw off using the red on/off
button (11, labelled "O").
Wait until the blade has stopped completely
before removing the workpiece.
Overload protection
This circular bench saw is equipped with
overload protection, which will automatically
switch the saw off if it is overloaded.
If this happens, leave the saw to cool down
for 30 minutes. Then press the overload
protection (11a), and switch the saw on again
by pressing the green on/off button (11,
labelled "I").

Cleaning and maintenance

Remove sawdust and dirt using a vacuum
cleaner, or a brush.
Check that the motor ventilation slots are not
blocked.
Wipe the exterior parts of the saw with
a dampened cloth. Never use strong or
corrosive detergents.
Lubricate all moving parts with a light
lubricating oil.
If the carbon brushes are worn down, they
must both be replaced.

Service centre

Note: Please quote the product model
number in connection with all inquiries.
The model number is shown on the front of
this manual and on the product rating plate.
For:
• Complaints
• Replacement parts
• Returns
• Guarantee issues
• www.schou.com
GB
57