Acetech iTracer Unit Manual De Instrucciones página 22

Press the power button on iTracer Unit to turn it on. If the power
5.
indicator blinks,it means the iTracer Unit is already powered on.
Rotate "mode selector" of iTracer CD to the following modes:
6.
After completing the above installation steps, you can start enjoying the
7.
pleasure of iTracer.
2 Each Unit of iTracer
2-1 iTracer CD : Command Display
The main functions of iTracer CD are data display, status display and executi-
on controlling and command transmission:
Multi-language display:English, German, Spanish, Russian.
●
Execution of commands and controlling transmission: Control and trans-
●
mit the execution command to iTracer Unit and iTracer SCU.
Data Display: Display the data of Count Up, Count Down, Muzzle Velocity
●
, Energy, ROF.
Status Display: Show the status of Multiple-Round Burst and of the
●
power and Volt of AEG battery.
ROF：Measure ROF (Rate of fire)
SPD：Measure muzzle velocity and energy
DN ：Execute "Count Down" function
UP ：Execute " Count Up" function
0 ： Power off
ST ：Turn on/off other functions and
set parameters
EN
21
EN