Acetech iTracer Unit Manual De Instrucciones página 25

● SPD mode:
Measure the Muzzle Velocity and Energy and pro-
vide the last 25 records .
When switching the mode to "SPD", the screen
will show "Speed" for 1 second and then enter the
interface of speed and energy measurement. After
that, you can fire your Airsoft gun to measure the
muzzle velocity and energy.
Remarks:
When switching the mode to "SPD", iTracer CD will transmit commands
to the following units :
iTracer Unit:
Turn off the illuminating function of iTracer Unit temporarily
(under SPD mode).It will be resumed when you switch to other modes.
iTracer SCU:
Switch multiple-round burst to full auto. You may not swap the
BURST/FULL AUTO under SPD mode. The number of BBs you fire under
SPD mode will not affect the current numbers of "Count Up" and
"Count down" but will still be counted in the "Total Shot" (A function
of "SET UP" mode.)
Rotate data knob clockwise/counterclockwise
to inquire the last 25 records.
Press
Press and hold data knob for 3 seconds to
remove all the past records.
Speed
Unit of Muzzle Velocity
Rec.0 m/s
J/cm
Unit of Energy
Number of record
2
EN
24
EN