Promaker PRO-TI20 Manual Del Usuario página 11

Vibration total values (triax vector
sum) determined according to EN
60745:
The vibration emission level given
in this information sheet has been
measured in accordance with a
standardised test given in EN 60745
and may be used to compare one
tool with another.
It may be used for a preliminary
assessment of exposure.
The declared vibration emission level
represents the main applications
of the tool. However if the tool is
used for different
with different accessories or poorly
maintained, the vibration emission
may differ. This may significantly
increase the exposure level over the
total working period.
An estimation of the level of exposure
to vibration should also take into
account the times when the tool is
switched off or when it is running but
not actually doing the job. This may
significantly reduce the exposure
level over the total working period.
Identify additional safety measures
to protect the operator from the
effects of vibration such as:
maintain the
accessories, keep the hands warm,
organisation of work patterns.
Vibration risk limitation suggestions:
1. wear glove during operation
2. limit operating time and shorten
applications,
tool and the
trigger time.
OPERATION
Before use
Remove any packing material and
loose parts from unit.
Check the accessories before use.
It should be fit with the machine and
your purpose.
If the machine is new, the battery
must first be charged.
Attention!
After long time storage, the
battery capacity will be reduce.
A new battery or one which has not
been used for an extended period
achieves full performance only after
approx.5 charging and discharging
cycles.
A substantial drop in operating
period per charge indicates that the
battery is worn out and must
be replaced.
Battery charger
The power voltage supply must
conform to that specified on the
rating plate of the rapid charger.
Always inspect battery charger, cord
and plug before use.
Always have damage repaired by a
qualified professional.
11