Promaker PRO-TI20 Manual Del Usuario página 12

Protect battery charger against
humidity and operate only in dry
areas.
The supplied charger is suitable for
charging batteries only.
Charging the battery
To start the charging process insert the
battery into charger following the slot,
then plug in the battery charger in.
The battery and charger become
warm during the charging Process.
This is normal.
After termination of the charging
process (about 3-5 hours), pull
charger plug out of socket and
remove battery from the charger
following the slots.
LED indicator:
Red indicator lighted: charge base
connects with power.
Green & red indicator lighted:
charging.
Red indicator turns off: charge
finished.
To prevent incorrect battery inserting
on the charger, please insert the
battery pack according to the slide
direction.
About the charger
Disconnect the feeding before
connecting or disconnecting the
battery.
The charger must be used only with
rechargeable battery. Never use un-
rechargeable battery.
Do not expose the charger to rain or
water.
The charger must be used with the
battery and with the adaptor.
Insertion and
Rechargeable Battery
Ensuring the correct orientation
between the
battery compartment, insert the
rechargeable
machine. Do not apply force when
inserting the battery. Insertion can
be achieved easily and without
resistance. The battery must be
inserted completely until the battery
retention clips on the sides of the
battery compartment automatically
lock it into place. To remove the
battery press the battery retention
clips and pull the battery out of its
compartment.
Inserting Tool Bits
Important! Always
battery before you change the drill
or screw bit to avoid unintentional
starting of the machine.
The cordless drill has a keyless
chuck so you do not need a key to
lock the tool bit in place. Make sure
Removal
battery and
battery into
remove
of
the
the
the
12