i.safe MOBILE IS-TC1A.M1 Manual De Instrucciones página 6

The device may only be used in zones 1, 21, 2, 22, M1 and M2.
The device must be protected from impacts with high impact energy, against excessive UV
light emission and high electrostatic processes.
Only accessories approved by i.safe MOBILE GmbH may be used.
USE IN EXPLOSION HAZARDOUS AREAS
DANGER
Improper use can result in death or severe injuries!
Only use the device in explosion hazardous areas of zones 1, 21, 2, 22, M1 and M2 or outside of
explosion hazardous areas.
Only connect the device outside explosion hazardous areas to the ISM interface of the
IS530.M1.
Before entering an explosion hazardous area with the device,
• make sure that the device is securely fastened to the ISM interface of the IS530.M1,
• make sure that no gap can be seen between the two halves of the device,
• make sure the device is not damaged,
• make sure that all the labels on the device are readable.
If you use the device in an explosion hazardous area,
read and follow the instructions in the "Possible User Errors" section.
Switch off the device immediately and leave the explosion hazardous area without delay if
• malfunctions occur on the device,
• you have damaged the housing of the device,
• you have exposed the device to excessive loads,
• the labels on the device are no longer readable.
POSSIBLE USER ERRORS
DANGER
Improper use can result in death or severe injuries! Follow the instructions below:
Do not modify the device structurally.
Do not expose the device to high temperatures.
Do not expose the device to strong UV radiation.
Do not expose the device to processes with high electrical charges.
Do not expose the device to aggressive acids or bases.
When working in explosion hazardous areas, please note:
Do not loosen the screws on the device.
Do not open any interface cover.
Do not charge the IS530.M1.
Do not open the device.
Do not damage the device.
6