Installing The Battery - REVAMP Professional iGEN PROGLOSS CORDLESS ST-2750 Guia Del Usuario

Please note:
Your straightener comes with a charging stand as well as a UK/EU charging adaptor and a
separate USB charging cable. You can charge your iGEN Progloss Cordless straightener:
• using the UK/EU charging adaptor with the USB-C end plugged into the battery of
your straightener
• using the UK/EU adaptor plugged into the charging stand (in this instance, you can
charge one or both batteries at the same time)
• using the USB charging cable plugged into any USB compatible device with the
USB-C end plugged into the battery of your straightener
• using the USB charging cable plugged into any USB compatible device with the
USB-C end plugged into the charging stand (in this instance, you can charge one or
both batteries at the same time)
• Please note you will need to allow around 3.5 hours for a full charge of one or both
batteries when using any of the above charging methods. The hair straightener will not
function while charging on the stand.
• While styling your hair, please make sure to keep the charging base unplugged,
otherwise your straightener will automatically turn off and charge.
• Warning: If the green LED light starts to flash rapidly then the appliance is faulty. If this
happens, please stop charging, remove the adaptor from the mains and contact our
Customer Care Centre for further advice.

INSTALLING THE BATTERY

Slot the battery into the recess at the bottom of the straightener and align the arrow
on the straightener with the unlock icon (please insert icon) on the battery, then twist
clockwise to align the arrow on the straightener with the lock icon to lock in place. To
remove, twist anti-clockwise to align with the unlock icon and pull
INSTRUCTIONS FOR USE
• Before use, ensure your hair is clean, dry and tangle-free.
• For extra protection, apply a heat defence spray.
• Section your hair prior to styling. Begin with the lower layers.
• Please ensure the Smart Flight Safe Mode (located on the inside of the straightener)
is unlocked before use. A white LED light will indicate that Smart Flight Safe Mode
(Feature 7) is unlocked and safe to use.
• Press and hold the POWER button
switched on, the straightener will heat up until it reaches its default temperature of
230°C.
• Press the POWER button
light indicating the selected temperature setting will move up as you press the POWER
button.
• REVAMP recommends beginning with the lowest heat setting on initial use before
increasing the temperature until the desired result is achieved. If you have fine,
delicate hair, use the lower heat setting. If you have thick or coarse hair, use the higher
heat setting.
• The white temperature indicator LED will flash until the straightener is ready to use.
When it reaches the selected temperature, the white LED will become constant. The
temperature selected will be locked after 3 seconds. When this happens, all 3 white
temperature LED lights will flash twice to indicate that the temperature selected
is being locked and can't be changed. This feature prevents any unintentional
temperature changes while using the product.
• To change the temperature of your straightener, quickly press the temperature control
for 3 seconds to switch on the product. When
again to select your desired temperature. The white LED