Instructions For Use - Nosiboo Pro2 Manual Del Usuario

5. Instructions for use

Do not aspirate water
with the device!
1. The device is ready for use.
2. Switch on the device by turning the control button.
The device should be connected to or
disconnected from the power network
only if the control button is in OFF position
(the device is switched off).
NOTE: Any time you are not actively using the device, switch it off.
After the motor cycles off completely, you can restart it.t
Do not use the nasal
aspirator for nasal washing!
3. Select the correct suction power.
low setting for newborns
medium setting for babies
high setting for small children and for
preschoolers
TIP: If the mucus is thin, you can use the device at a lower setting. If
it is thick, you can use the device at a higher setting than normal.
4. Hold your child in a stable position.
Sit your child onto your lap, hold them in your arms or sit them into
an upright position supporting their back with a pillow. You may
also sit them in an infant bouncer or infant seat.
5. Insert the clean, dry nose tip into the child's nostril.
In case of newborns, it is sufficient to hold the nose tip at the open-
ing of the nostril. The connection point of the connecting tube
should point downwards while in use.
NOTE: In case of swollen nasal mucosa or blocked nasal openings,
use decongestant solutions or nasal sprays 30 minutes before
application.
6. Move the nose tip around gently to make sure that you get all
areas of the nostril.
NOTE: Do not pinch or block the other
nostril while using the nasal aspirator.