Beurer LV 50 Manual De Instrucciones página 22

Replacing the evaporation filter
The evaporation filter should be replaced with a new one after 1000 operating hours. After 1000
operating hours have elapsed, the FILTER indicator will light up on the display. To replace the
evaporation filter, proceed as follows:
1. Ensure that the table fan is switched off. Disconnect the table fan from the wall socket or computer.
Pull the PET bottle and bottle adapter straight up and off.
2. Press the front and rear housing release latches to release the
housing. Then carefully pull the housing upwards to remove it,
as there may still be residual water in the water basin.
3. Pull the filter cartridge up and off.
4. Place the new filter cartridge into the water basin from above.
5. Place the housing onto the water basin from above until you
hear and feel it click into place.
6. To turn off the FILTER indicator after replacing the filter, press
and hold the ON/OFF button and the FAN button simultane-
ously for 10 seconds. If you want to replace the filter before
the 1000 operating hours expire, proceed as follows: press
and hold the ON/OFF button and the FAN button simulta-
neously for 10 seconds, even if the red filter indicator is
not illuminated. The filter indicator will flash red for 3 sec-
onds. Once the flashing has stopped, it means the counter
has reset.
22
2.
1.