8. WHAT IF THERE ARE PROBLEMS?
Problem
The table fan cannot be swit-
ched on.
Insufficient passage of air.
Table fan smells unpleasant.
The table fan is very loud.
9. DISPOSAL
For environmental reasons, do not dispose of the device in household waste at the end of
its service life. Dispose of the device at a suitable local collection or recycling point in your
country. Observe the local regulations for material disposal. Dispose of the device in ac-
cordance with EC Directive – WEEE (Waste Electrical and Electronic Equipment).
If you have any questions, please contact the local authorities responsible for waste disposal.
You can obtain the location of collection points for old devices from the local or municipal
authorities, local waste disposal company or your dealer, for example.
Possible cause
Table fan is not plugged in.
The table fan is faulty.
The evaporation filter is dirty.
The ventilation grille blocks the
air flow.
The ventilation fan is new.
The water in the PET bottle is
stale.
The evaporation filter has been
damp for too long.
The table fan is standing on an
unstable and uneven surface.
24
Solution
Connect the table fan to a suita-
ble wall socket or computer.
Please contact Customer Servi-
ces at: www.beurer.com
Clean or replace the evapora-
tion filter (see "Cleaning and
maintenance" chapter).
Open the ventilation grille to
allow air to flow through.
Unplug the table fan. Then em-
pty the water basin and allow it
to air for 12 hours.
Replace the water in the PET
bottle.
Allow table fan to run without
PET bottle, so that the table
fan can dry out the evaporation
filter.
Remove the evaporation filter
(see "Replacing the evaporation
filter" chapter) and allow it to
air dry.
Place the table fan on a stable
and level surface.