Installation Instructions - afx light HAZE800 Manual De Instrucciones

• Operate the device only after having familiarized yourself with its functions. Do not permit ope-
ration by person not qualified for operating the device. Most damages are the result of unprofes-
sional operation.
• For safety reasons, please be aware that all modifications on the device are forbidden. Further-
more, any other operation may lead to short-circuit, burns, electric shock, lamp explosion, crash,
etc. If this device will be operated in any way different to the one described in this manual, the
product may suffer damages and the warranty becomes void.
• When you use the fog machine on a wooden floor or ground with carpet, the machine should ne-
ver be directly in contact with the ground. The machine should keep a distance with the ground
of 50cm at least. It's not allowed to put flammable and explosive objects within 5 meters
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect
device shall remain readily operable.
IMPORTANT NOTES
• Before filling the fog liquid, please unplug the unit from the mains.
• In order to prevent short circuits, please don't let fog liquid flow into the inner part of the machine
before filling, you can also take out the liquid bottle and fill in the fog liquid outside the unit.
• The fog machine must be installed on the ground. It's not allowed to slope the unit or place it
upside down
• After use, switch the fog machine off and unplug it from the mains
• The fog machine isn't waterproof. If moisture or fog liquid enters inside the machine, you must
unplug it immediately from the mains and contact your dealer.
• It's forbidden to spray directly towards persons. Keep far away from flammability and explosive
objects
• The fog spray is very hot, please keep a distance of at least 5 meters when using it
• Please don't touch the surface of the fog machine during the use because the housing will reach
40-80°C
• When the machine doesn't work, please check if the fuse is burnt out or not. If it is, replace it by
an identical fuse, find out the fault and restart the machine. But please note: the repair must be
carried out by a professional.

INSTALLATION INSTRUCTIONS

Install the fog liquid
Unscrew the cap of the fog liquid bottle and fill the fog liquid. After filling, screw tight the cap of the
fog liquid bottle to avoid fog liquid leaking out.
OPERATION
After power on, the display will show HEAT, which means that the machine is heating-up. Once it
has reached operating temperature, it can produce haze all the time.
Display FUNCTION
ON/OFF Haze ON/OFF (press UP/DOWN to switch)
P001-P010 Haze output volume adjustment (press UP/DOWN to adjust)
Clr0-Clr1 Self-Clean function OFF/ON. (Press UP/DOWN to switch)
Timer interval setting: Press UP/DOWN buttons to adjust. The unit will always
activate the output for about 30 seconds.
t000-t060
You can set the interval between these activations from 000 (continuous out-
put) to 60 (+/-60 seconds)
d001-d512 DMX address setting. (press UP/DOWN to adjust)
www.afx-light.com
3 EN