afx light HAZE800 Manual De Instrucciones página 4

DMX-512
This product has 1 DMX channel:
DMX CHANNEL
Channel 1
OPERATING INSTRUCTIONS
Put the haze machine on a flat and very stable surface. Make sure that nobody can put their hands
just in front of the output. The fog is very hot and can cause serious burns!!!
Make sure the fog liquid tank is not empty.
Always use good quality fog liquid to fill up the tank.
Close the tank immediately to prevent dirt to enter the reservoir!
Make sure to plug the haze machine in a mains wall outlet with earth connection.
Switch the machine on and wait for about 2-3 minutes (warm up time)
When the machine is ready, use the control panel to select the desired continuous fog output.
WIRELESS REMOTE
Wireless remote has two buttons, Button A/B:
Button A: Haze output ON.
Button A: Haze output OFF.
For the wireless remote: Button A is haze output ON, Button B is haze output OFF (haze volume
"Zero"). Please set the haze output volume on display in advance.
INSTALLING THE BATTERY IN THE REMOTE CONTROL
• Place the remote face down on a flat surface.
• Push the compartment cover into the direction of the arrow to slide the battery compartment
open.
• Remove the old battery and install the new one (23A 12V alkaline) with the correct polarity.
• Gently slide the battery compartment closed. It locks automatically.
RECOMMENDATIONS FOR BATTERIES
This symbol indicates that used batteries should not be disposed of with household waste but deposed correctly in accordance with
your local regulations..
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or corrosion.
: Danger of explosion if battery is incorrectly placed. Only replace by the same or equivalent type.
ATTENTION
:Do not swallow the battery. Danger of chemical burns. Keep new and old batteries out of the reach of children.
WARNING
If the battery compartment doesn't close properly, stop using the product and keep it out of the reach of children.
If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body, contact immediately a doctor.
IF YOU DON'T USE THE MACHINE ANYMORE
IMPORTANT: DO NOT JUST TURN OFF THE POWER OR UNPLUG THE POWER CORD WHEN YOU
WANT TO INTERRUPT OR STOP THE PRODUCTION OF FOG. Always set haze volume to Zero output
and wait for about 1 to 2 minutes before you switch off the unit. This allows the unit to start up
its cleaning process so that all remaining fluid is removed from the internal circuits. If you are not
using the remote controller, then select [HAZE] OFF on the control panel via the [MENU] button and
also wait for about 1 to 2 minutes before you switch off the unit. Switch off the unit, unplug the
mains cable and wait until the unit has cooled down.
EN 4
VALUE
000-005
006-255
FUNCTION
OFF
Haze output volume 1-100%
© Copyright LOTRONIC 2022