IKEA VATTENSTEN Manual De Instrucciones página 17

FCC15
English
This device complies with Part 15 of
the FCC Rules.
This device contains licence-exempt
transmitter(s)/receiver(s) that
comply with Innovation Science and
Economic Development Canada's
licence-exempt RSS standard(s).
Operation is subject to the following
two conditions:
(1) this device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation of the
device.
WARNING:
Any changes or modifications to this
unit not expressly approved by the
party responsible for compliance
could void the user's authority to
operate the equipment.
NOTE:
This equipment has been tested and
found to comply with the limits for
a Class B digital device, pursuant
to part 15 of the FCC Rules. These
limits are designed to provide
reasonable protection against
harmful interference in a residential
installation.
This equipment generates, uses and
can radiate radio frequency energy
and, if not installed and used in
accordance with the instructions,
may cause harmful interference
to radio communications.
However, there is no guarantee
that interference will not occur
in a particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the quipment off and
on, the user is encouraged to try to
correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between
the equipment and receiver.
• Connect the equipment into an
outlet on a circuit different from
that to which the receiver is
connected.
• Consult the dealer or an
experienced radio/TV technician
for help.
Français
Ce dispositif est conforme à l
a section 15 des règlements de
la FCC.
Ce dispositif contient un ou
plusieurs émetteurs/récepteurs
sans licence qui sont conformes
à la ou aux normes RSS sans
licence d'Innovation, Sciences
et Développement économique
Canada.
Le fonctionnement est soumis aux
deux conditions suivantes :
(1) L'appareil ne doit pas produire de
brouillage,
(2) l'appareil doit accepter tout
brouillage radioélectrique subi,
même si cela est susceptible
de compromettre son
fonctionnement.
ATTENTION :
Tout changement ou modification
apportés à cet appareil sans
approbation expresse de la partie
responsable de la conformité
peut rendre nulle la capacité de
l'utilisateur à utiliser cet appareil.