Connections; Operation - Gastrodomus EVOQUE Manual Del Usuario

3.0 Connections

3.1 Check if the equipment is designed to operate at the voltage and frequency with which it will be
powered. Check the data plate of the equipment.
3.2 Check the condition of the product for impact damage, scratches, or loose screws before positioning
the oven for installation.
3.3 After connecting the appliance to the power supply, press the power button , then check the
temperature controller and its buttons .
3.4 Pay attention and observe the steps listed above before using the oven . Report if any malfunctions are
found immediately .
Check the screws, they may have loosened during transport.
3.5 This furnace is connected to a fixed wiring harness that lasts over time. An installation technician can
provide the power cord (YZW) to connect to the electric furnace.
3.6 Equipotential bonding , connect the electrically powered equipment to an effective earth ground. These
are conductors that connect parts that are normally at earth potential to each other thus ensuring
equipotentiality between the earth system and extraneous masses and allowing the overall resistance of
the earth system to be reduced.
3.7 The oven must be at least 50 cm away from the wall.
3.8 The appliance must not be used in wet areas or outdoors.

4.0 Operation

4.1 After installation or maintenance work, check the operation of the equipment.
Turn on the oven and press the thermometer button, adjust the temperature, if the indicator light is green
it indicates that the oven is on and the temperature is rising, if the indicator light is red it indicates that the
oven is off. It is possible to turn the oven on and off manually by pressing the button .
4.2 The upper and lower temperature setting can be adjusted and used individually or simultaneously.
4.3 You can adjust the upper and lower temperature according to your needs. The forced hot air ensures
that the oven reaches the required temperature in a short time, guaranteeing uniformity of cooking even
when fully loaded.
4.4 It is not recommended to open and close the door frequently.
4.5 Do not obstruct the ventilation system of the room where this appliance is installed.
4.6 This appliance is equipped with a manual reset safety thermostat that stops heating when the operating
temperature exceeds the maximum allowed temperature. To reset operation of the appliance, it is
necessary to remove the control panel and press the thermostat reset button. This operation should only
be performed by a qualified and licensed technician.
10