All manuals and user guides at all-guides.com
GENERAL
This symbol indicates WARNING. Per-
sonal injury and/or damage to property
may result if the instructions are not
followed carefully.
This machine is available in two versions.
• Compact, manual transmission, designated
Compact.
• Compact, hydrostatic transmission, designated
Compact HST.
ASSEMBLY
To avoid injury and damage to people
and property, do not use the machine
until all the measures under "ASSEM-
BLY" have been carried out.
ACCESSORIES BAG
The machine is supplied with a plastic bag contain-
ing components which must be installed prior to
use. The bag contains (fig. 1):
Pos. No. Designation
A
1
Spark plug sleeve
B
1
Torsion pin ditto
C
1
Tension pin
D
1
Shim washer
E
1
Shim washer
F
2
Shoulder washer
G
2
Screw
H
2
Wing nut
I
2
Washer
J
1
Drawing plate
K
4
Screw
L
2
Nut
M
1
Gear lever (not HST)
Spare key
ENGINE CASING
To fill with fuel and to inspect and maintain the en-
gine and battery, open the engine casing. The en-
gine must not be running when the casing is
opened.
Opening:
1. Raise the seat lock (fig. 2) and fold the seat for-
wards.
2. Pull up the rubber strap at the front edge of the
ENGLISH
casing (fig. 3).
3. Grasp the front edge of the engine casing and
fold up the casing (fig. 4).
Closing:
1. Grasp the front edge of the engine casing and
fold down the casing (fig. 4).
2. Secure the front edge of the casing with the rub-
ber strap (fig. 3).
BATTERY
The battery is a valve-regulated battery with 12 V
nominal voltage. The battery is completely main-
tenance free. You don't have to check or top up the
electrolyte level.
On delivery, the battery is in the accessories box.
If the machine is not going to be used for an ex-
tended period (more than 1 month), the battery
should be charged, disconnected and then stored in
Dimension
a cool, safe place. Charge the battery completely
before reinstalling.
6 x 36
The battery can be charged in two ways:
16 x 38 x 0.5
1. Via a battery charger (recommended). This must
16 x 38 x 1.0
be a charger with constant voltage. The battery
can be damaged if a standard type battery
8 x 20
charger (for acid batteries) is used.
Stiga recommends battery charger with item no.
8.4 x 22 x 1.5
1136-0602-01 which may be ordered by an au-
thorised dealer.
8 x 20
2. You can also allow the engine to charge the bat-
tery. In this case it is very important, above all
when starting the machine for the first time and
when it has not been used for a long time, to al-
low the engine to run continuously for at least
45 minutes.
The battery must be fully charged be-
fore being used for the first time. The
battery should always be stored fully
charged. If the battery is stored while
totally flat it could sustain permanent
damage.
Do not short circuit the battery's termi-
nals. Sparks occur which can result in
fire. Do not wear metal jewellery which
can come into contact with the battery
terminals.
In the event of damage to the battery
casing, cover, terminals or interference
GB
13